top of page

1. Cleaning and Maintenance.


Your Puffco Peak Vaporizer needs to be cleaned Daily for best performance:

 

  1. *Remove the glass bubbler.

  2. *Handle extra care when handling your  bubbler, First clean the carb cap and the glass piece by soaking it onto a solution of 91%isopropyl alcohol.

  3. *Leave it in the solution for 30 min to an hour and rinse it with warm water and soap,Dry with a paper towel and set aside.

  4. *Take the atomizer and soak onto the same solution you used when cleaning the glass bubbler. Drop the fully assembled atomizer into ISO for Overnight.Dry with a paper towel and set aside.

  5. *Make sure that all the components  are completely dry before attaching it to the Puffco Peak body. This can cause liquid to trickle down to the battery and make its way to some of the sensitive internal circuitry which can cause permanent damage. Be sure not to let any liquid make its way to the battery.

 

WARNING: 
*After cleaning, allow all parts to thoroughly dry before use. (ISO is flammable)
*Do not get the base wet – it’s electric – it will break.
*Do NOT attempt to disassemble the atomizer before submerging fully assembled into ISO.

2. Multi-Colored LED Lights


Puffco Peak is equipped with an LED light system that tells you the actual status of the Puffco Peak. Here’s what you should look out for.

3 Red Flashing Light – Low Battery Level.
5 Flashing Light – Short Circuit.
Solid Red Light – Overheating.
Make sure to be careful looking after the LED lights to tell what’s wrong with the Puffco Peak. Apart from what the Puffco Peak tells you with its LED lights, here are some of a few things you should avoid when using the Puffco Peak.

3.Temperature Settings.


Puffco Peak  4 unique temperature profiles.

The different temperature settings are categorized or named as low, medium, high, and peak. Lower temperature level is at 450 degrees heating up at 20 seconds and works well with small loads of concentrates. The medium heat profile runs at 500 degrees and reaches peak temperature at 20 seconds and works well with medium sized loads of concentrates. The high temperature level is at 550 degrees and reaches vaping temperature at 25 seconds and works best with large loads of wax concentrates. Finally, the aptly named peak temperature setting heats up your concentrates at 600 degrees and has a 25 second heat up time and can vaporize XL loads of concentrates.

To cycle through these temperature levels simply press the power button once.

4. Battery Level.


The Puffco Peak lets you check the battery level so you’d know when it’s time to charge your device. The battery is represented in three levels. High, mostly colored in green means that your battery is around 100 – 60 percent while medium or yellow means that you’re running at 60 – 30 percent of battery while low or red means you’re at 15 – 0 percent of battery power.

 

Never Do The Following:

 

Be mindful of the water level of the glass bubbler.

Do not overfill the glass bubbler.

Fill it with water just above the air holes.

Never store the Puffco Peak with water on the bubbler.

Remove and replace the glass bubbler carefully and do not apply too much force.

When connecting threaded components, apply enough force and stop when you feel resistance.

During use, wait for a minute before using again. Allow the unit to cool down.

Avoid heating the atomizer 4 times in a row.

If you encounter a software issue, turn the Puffco Peak off and on.

When in use and you want large cloud production, take several short draws instead of long drags.

Do not overfill the bowl.

When loading avoid wiping off the concentrates on the side of the bowl.

Avoid storing the Puffco Peak on a moist and humid area.

Avoid storing the Puffco Peak in places that are extremely hot or extremely cold.


©2020 by Peakcoil Repair

bottom of page